![]() ![]() Give the Target, Protocol in, Protocol out, and Baud rate values according to the below image. Scroll down and select the PRT (ports) option. Step-7 Go to the View option and select the Configuration View option. CC3D flight controller works only with the minimum messages (VELNED, SOL, DOP, POSLLH). Note- By using this configuration we cannot display the GPS plugin because GPS does not send SVINFO messages. You can see the save button in the red circle. Now, save the current configuration by clicking on save current receiver configuration at the top menu bar. Go to the UBX option and enable the following in NAV (navigation) and NAV2 options. Step-6 Go to the View option and select the Message View option. Now click on the send option at the bottom of the configuration window. Now, click on CFG (configuration) option on the left-hand side and select the Revert to default configuration option. Step-5 Go to the View option and click on the Configuration View option. If it is not showing any GPS output then try to connect it again and follow the same process. You should see message output from your GPS in the packet console window. Step-4 Go to the View option and click on the Packet Console option. If you are not able to see your COM port in this connection then you have to install a driver for it. COM port option will be converted into green color after stabilizing the connection. Step-3 Now, select the COM port for your GPS module. You will see the below screen on your PC. Step-2 After stabilizing the connection between the TTL module and GPS. Now, insert TTL module USB in your PC and open the U-center v.21.09 software. You have to do a serial connection between the GPS module and USB to the TTL module. Step-1 Connect USB to TTL module with Neo-6m GPS according to the given table and circuit diagram. And follow the below steps to configure your GPS. Components Required for Interfacing GPS with CC3D Flight ControllerĬonfiguring GPS for CC3D Flight ControllerĪfter downloading the u-center v.21.09, you need to install it. One thing you should remember is that this software is for only windows. In the below image, you can see the blue circled downloadable link. ![]() You can download the u-center for windows (v.21.09) by using this link. U-center is a powerful GNSS (Global navigation satellite system) evaluation and visualization tool that enables end-users to evaluate and test the navigation and positioning performance of u-blox GNSS positioning chips and modules. Prerequisiteįirst, you have to download U center software. In this tutorial, we will see how to set up a GPS module using the TTL module and after that, we will interface the CC3D flight controller with the GPS module (Neo-6m). The only reason for employing GPS is for telemetry via radio modems (OPLink) or to relay GPS position to an OSD device. GPS is used in drones for many purposes like position hold, delivery, return to position, and many more but the CC3D flight controller does not support the return to base and position hold functionalities as it does not have enough memory for that. In this tutorial, we are going to interface the CC3D flight controller with the NEO-6M GPS module. CC3D (Copter control 3) is a flight controller, which is developed by Open Pilot and is completely open-source. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |